The fans seem to run suprisingly well in a static pressure situation.
The medium fan speed setting at first sets the fan to full speed but then slows the fan down after a few seconds. Luckily the remote has slow (ws1), medium(ws2), and fast(ws3) fan speed settings. First of all the PWM setting on the remote doesn't appear to actually take the motherboards PWM signal (or if it does the signal saturates) and instead seems to turn the fans on to full speed. There are a few things that I wish was capable on these fan. This is an extremely small problem that I'm sure wouldn't bother 99.9% of builders and would likely still looks great without any adjustments. I had to flip many of these stickers and straighten them. The static logo on the back of the fans was upside down in many situations and also not perfectly straight. The second is the black and white stickers that they use for their logo in the center of the fan. Even if the deviders are small they are still visible. The first is if the LED halo was one continuous halo and not broken up into 4 sections. There are two things I think could improve the appearance of these fans.
The color quality is great, they have a clean color pallet including a Sharp white that I'd say is even whiter than Corsairs! These fan sit right in the middle with the ability to be accent lighting, full on RGB unicorn vomit, or completely inconspicuous with the LEDs off. These fans look great! They are not too in your face like some LED fans that light up the entire fan but they also aren't boring like traditional non-LED fans. My problem isn't yet but I found this video I'm assuming I'll need a converter of some kind or go without rgb but I'm not sure PCCOOLER - how to install 5 in 1 fan kit | Facebook Is the software simply not seeing the fans or does it see them but fail to control them?I added a screen shot on my first post that I hope helps out.Įach fan has a fan header and a rgb header Enable support for the fans through only one lighting control software package/Īlso, please describe what about RGB part is not working. NOTE: Having more than one lighting package can cause difficulties as they may "step" on each other. Since the spinning fan portion is working we won't bother with that, but could you describe how the lighting is hooked up? I can't find any docs for those fans, but as best as I can tell, you should have the following:ġ) SATA Power connected to the controller that came with the fans.Ģ) I'm assuming that the controller also connects to a USB 2 header on the MB in order to provide lighting control.ģ) Installation of one of the supported ligting software packages such as MSI Mystic Light.
0 kommentar(er)
